Page 1 of 1

NZB not saving column widths

PostPosted: Tue May 10, 2011 4:10 pm
by rbswft
Using B13, seems very stable, just a little annoying thing.

When open up a NZB, move the column widths so can see all content, then when close it seems to reset again to small widths.

I move SUBJECT column to longer width, close the nzb and open either a new one or same again, it resets itself.

Am I missing something?

Was saving widths in B12

Apart from this all looking/working great.

Cheers.

Re: NZB not saving column widths

PostPosted: Tue May 10, 2011 4:16 pm
by Quade
Known issue in B13. If you install B12, set the widths, then install B13 without wiping the gui configuration, it should maintain the column widths you set in 12 (which is why I missed this issue).

Re: NZB not saving column widths

PostPosted: Tue May 10, 2011 7:07 pm
by rbswft
Cheers, many thanks for response.

Re: NZB not saving column widths

PostPosted: Tue May 10, 2011 10:14 pm
by Alienns
Where can i download beta 12 to set positions than install b13 again?